The digits on either the red or the black gateway display the Gateways status. Indicators on both gateways mean:

Indicator 1 (PWR): Intergas gateway powered ON.
Indicator 2 (WAN): Connection between gateway and Intergas server established.
Indicator 3 (LAN): Connection between gateway and home network established.
Indicator 4 (RF): Connection between gateway and boiler established.
Indicator 5: Control.

If the first four indicators are illuminated then the connection is performing properly. If this is the case and the message ‘Gateway not available’ still appears on your phone please check the time settings on your phone.

In some cases the time settings on your phone are set to manual instead of automatically. Because of this there can be a time difference in the time perception between your phone and the Intergas Gateway. If you device is ahead of the current time this may cause the message ‘Gateway not available’.

Our advice is to set the time settings on your device to automatic. In most cases this solves the problem. Check the manual of your device to see how to change this.

Red gateways with red indicators have been available since 2014. Our black Intergas gateways with illuminated digits have been available since the beginning of 2018 and will be replacing red gateways. These digits or indicators display the gateway’s status. Indicators on both gateways mean the same thing:

• Indicator 1 (PWR): Intergas gateway powered ON.
• Indicator 2 (WAN): Connection between gateway and Intergas server established.
• Indicator 3 (LAN): Connection between gateway and home network established.
• Indicator 4 (RF): Connection between gateway and boiler established.
• Indicator 5: Control.

If this is the case, then a DHCP server cannot be found on your network. This is a server that assigns IP addresses on networks and the internet. Possible solutions:

• Turn on DHCP on your router.
• Configure static network settings for your gateway (see below for instructions).

The gateway connects to your boiler via an RF signal. If only the first three indicators are illuminated, then something is wrong with this RF connection. Try moving your gateway away from any large, metal objects. Other causes/solutions:

• Your boiler is not connected, repeat the connection process.
• If this fails, check whether your boiler is RF-compatible.
• Do not place your gateway inside metal cabinets.
• The RF signal is too weak, move your gateway closer to your boiler.
• Move your gateway away from large metal objects.

If this is the case, there is no response from the Intergas server. Possible causes/solutions:

• Check whether you have a working internet connection.
• The Intergas server is down for maintenance or offline. Try again later. If you’re still experiencing problems, please email us at intouch@intergasheating.co.uk or call us on 01527 888000

Warning: Performing a factory reset will wipe any network connection settings you may have entered manually.

• Disconnect the power supply and wait 10 seconds before plugging it back in.
• While the five indicators are still ON, disconnect the power supply again.
• Factory settings will have been restored once indicator 1 turns OFF and the remaining four indicators remain ON.
• Repeat steps 1 and 2, if required.